What Should Be Paid Attention To If The Pressure Distribution Of The Electronics Heat Sinks Is Uniform

What should be paid attention to if the pressure distribution of the Electronics heat sinks is uniform

The electronic heat sink reduces the extrusion pressure on the working belt of the die by allowing the metal to flow in both directions, resulting in an even pressure distribution. The wall thickness of the special-shaped section of the four-column radiator is very different. When designing the tooling belt, the following points must be paid attention to: the working belt with large wall thickness should be particularly large, up to 20mm≤30mm, and the tooth tip should break through the routine to minimize the belt. All in all, the metal flow should be uniform. For the four-column radiator, in order to ensure that the mold has a certain rigidity, the thickness of the mold should be appropriately increased. Its thickness is increased by 30%-60%. The molds are also well done. The empty blade should be symmetrical up and down, left and right, and in the middle. The machining error of the gear should be less than . The thickness of the four-column radiator heat sink is uneven, and even the broken teeth are uneven, which is prone to local teeth. Pros and cons of material (purity, thickness, machining accuracy, etc.) and manufacturing process (cracks caused by casting, shrinkage, etc.), as well as rough, defective processes.